Matt circuit

Here is a simple circuit of wire-break alarm that activates after a delay of 15 to 30 seconds. When the thin-wire loop running across the entrance door is broken, the alarm sounds after a delay of 15 to 30 seconds, the time period set through VR1. Thus the occupants get sufficient time to lock the room from the outside and catch the thief.  The circuit uses CD4060, which is a 14-stage ripple-carry binary counter/divider and oscillator. It is wired as a timer here and does not need input pulse for trigger. CD4060 gets activated as soon as the power supply is switched on. Output O13 of CD4060 goes high after the lapse of preset delay set through VR1. Transistor SL100 (T2) is wired as a switch to power the timer section built around CD4060. When the wire loop is closed, transistor T2 does not conduct. So power to the timer circuit is not available and the piezobuzzer does not sound.  Wire-Break Alarm With Delay Circuit Schematic On the other hand, when the wire loop is broken by ...

Here is an inexpensive auto cutoff circuit, which is fabricated using transistors and other discrete components. It can be used to protect loads such as refrigerator, TV, and VCR from undesirable over and under line voltages, as well as surges caused due to sudden failure/resumption of mains power supply. This circuit can be used directly as a standalone circuit between the mains supply and the load, or it may be inserted between an existing automatic/manual stabilizer and the load.  The on-time delay circuit not only protects the load from switching surges but also from quick changeover (off and on) effect of over-/under-voltage relay, in case the mains voltage starts fluctuating in the vicinity of under- or over-voltage preset points. When the mains supply goes out of preset (over- or under-voltage) limits, the relay/load is turned ‘off’ immediately, and it is t...