Matt circuit

This circuit use IC TDA1004A to main operation .IC is very nice and durable if used properly and correctly, by the way supply the correct voltage , don't supply more voltage than 20 volts, because it can damage the IC. This circuit suitable for subwoofer speakers, but this amplifier  is mono.See schematic and troubleshooting below : If the circuit above not working , posible cause is on : Supply voltage. IC Damaged or installation inverted. Component damaged . Installation components inverted. Line break PCB. Input not connected or input connect to ground. Output speaker not connected.

This system needs to be attached to an existing car stereo amplifier to add extra ‘boom effect’ to the music. It has a dedicated loudspeaker with a power amplifier to boost low frequencies that are normally omnidirectional. Fig. 1: Circuit diagram of the subwoofer for cars Fig. 2: An actual-size, single-side PCB for the subwoofer Fig. 3: Component layout for the PCB The power amplifier used is an integrated class-B output amplifier in a 17-lead single-in-line (SIL) power package. It contains 4×12W single-ended (SE) or 2×24W bridge-tied load (BTL) amplifiers. The output speaker is connected in BTL configuration in this system for better quality. Circuit and working Fig. 1 shows the circuit diagram of sub-woofer for cars. It is built around low-noise JFET-input operational amplifiers TL072 (IC1), car radio power amplifier TDA8561Q (IC2) and transistors BC547 (T1 and T2). IC2 has two 24W BTL output channels, one of which is connected to loudspeaker LS1. BTL is an output configuration for ...